tractors we sell were sold new overseas in Japan. There is a plethora of them because of laws that encourage the tractor owners to upgrade often. They are then restored, mostly overseas, and then imported. We have an affordable product to
sale with consistant quality and reliability.
Here at Big Little Tractor we try
to keep a good variady of units from 16 horsepower to 52 horsepower. The 16 hp tractor are just a bit larger than a riding lawn mower, although much heavier. The 16 hp tractor will lift 6 to 700 lbs in the bucket. The 52 hp weighs in at 4300 lbs including
loader and can lift 1100 lbs in the loader bucket.
The restoration on the tractor is extensive and .The reconditioning of our imported Japanese
tractors goes as follows: the overall reconditioning is to 95% but not limned to , new pistons, rings, and bearings, new head gasket, new or rebuilt pumps,new air filter, new fuel filter, and new oil filter, the cylinder head is reconditioned, the clutch and
throwout bearing are new or reconditioned, the transmission is in good working order, hydraulic filter can be new or reconditioned, or if a metal screen will be cleaned . The front axle of fourwheel drive tractors have been cleaned and repaired as needed the
electrical system is working and the charging system is putting out is required voltage to charge the tractors battery, the belts and hoses are 95% of new or replaced with new, tires in front and rear are new or used without cracks or wear, the seat and paint
There are some differences in tractors built for the USA market versus those intended for the Asian market. However the differances
are small and there are advantages both ways.
1) The Tractor Power Take Off (PTO) in Japan has several speeds, but in the USA market there
is only one speed (540 RPMs). The Japenese tractors we sell come with multiple PTO speeds, including 540 RPMs.
2) ROPS (Roll Bars) are not required on Japanese
tractors, so we add them for the US market.
3) The fuel throttle on a Japanese tractor pulls down for more speed. The opposite is true on the
4) There are guards requierd in the USA market that are sometimes left off the Japanese models. We make sure they are
added on the tractors we sell, as well as seat belts and ROPS,( Roll Over Protection) and a Over Run Clutch (ORC).
As I mentioned earlier,
we replace all clutches. We have competition that neglects to replace the clutch. These tractors come from a very humid area and the clutch and presure plate see rust and must be replaced. So we always replace them.
The loaders we sell on our tractors are of high quality and built over seas. They are engineered and built to fit
the size of tractor and model; not a loader made to fit many different size of tractors. Our loaders are always a perfect fit.
We are an Internet sales company and therefore we don't have a regular store front. That being said, call anytime and make an appointment and I will do my best to meet up and show you the product
we have in stock. We always try to leave Saturdays open for showing; but call for a appointment for anytime during the week as well.
Phone and text: